Operating Systems > Linux and UNIX

Ph*ck! Help!

(1/2) > >>

rtgwbmsr:
OK, I'm on my Mac right now...
I installed pretty much a full installation of Red Hat. It restarted after it finished, and now it just says "GRUB" on a black DOS-esque screen. It doesn't boot, it doesn't do anything. Putting in the boot disk did the trick, but only gets me to Red Hat...I can't get into any of my other OSes! HELP!

Thanks

BTW: I've installed Red Hat before, and never had problems.

rtgwbmsr:
Progress!
When I check the LILO configuration, it says "Fatal: Kernal doesn't support initial RAM disks" WTF does that mean?

Master of Reality:
i dont know about this but could it be that you should have set the amount of memory to pass to the kernel in lilo/grub. (mem=128M or whatever).... but then it shouldnt even work with a boot disk...

rtgwbmsr:
Hi from me using Red Hat!
At least if I'm stuck in it...the internet works.

I'm going to go fishing for a solution. Any other help is greatly appreciated.

rtgwbmsr:
Here is my grub.conf file if it can help diagnose the problem:
# grub.conf generated by anaconda
#
# Note that you do not have to rerun grub after making changes to this file
# NOTICE:  You do not have a /boot partition.  This means that
#          all kernel and initrd paths are relative to /, eg.
#          root (hd1,0)
#          kernel /boot/vmlinuz-version ro root=/dev/hdb1
#          initrd /boot/initrd-version.img
#boot=/dev/hdb1
default=1
timeout=10
splashimage=(hd1,0)/boot/grub/splash.xpm.gz
title Red Hat Linux (2.4.18-3)
   root (hd1,0)
   kernel /boot/vmlinuz-2.4.18-3 ro root=/dev/hdb1
   initrd /boot/initrd-2.4.18-3.img
title XPee
   rootnoverify (hd0,0)
   chainloader +1

Navigation

[0] Message Index

[#] Next page