Operating Systems > Linux and UNIX

mouse protocol?

(1/2) > >>

crm:
I installed vectorlinux 3.2 and when i start x the mouse doesnt move! When i exit the is a message that says can not find mouse protocol. The mouse is a USB Memorex RF wireless optical mouse. Any ideas?

Abigail:
I think It won't move because it's an USB mouse.
To make it work, follow these steps:
(you must be logged in as root   ;)   )

1. Load the usbcore kernel module
   "modprobe usbcore"

2.

Find out which module you need for your USB interface. Try Loading each module with the command "modprobe [module name]" (you can choose between "usb-ohci" "usb-uhci" or "uhci")
If you get some error messages, then you didn't load the correct module, so try a diffrent one.

modprobe usb-uhci
OR
modprobe usb-ohci
OR
modprobe uhci

(err you understand right?    )

3. Now that you have the correct USB interface driver installed, load the modules hid and mousedev.
"modprobe hid"
"modprobe mousedev"

4. Now you may need to add an entry to /dev for the new mouse. If you don't have the file"/dev/mice" then you will need to add the following.

mknod /dev/mice c 13 63


5. If you want to use the mouse with X-Windows (I bet you want), then you will need to have the following lines in the mouse section of your  XF86Config file.

Option"Protocol""ImPS/2"
Option"Device""/dev/mice"


If you have similar lines in the mouse section, as you should then just change them to match the above lines.

Now restart X and use your mouse    

[ February 20, 2003: Message edited by: Abigail ]

Abigail:
oh well I always add /dev/mice with major number 13 and minor number 63 for some reason  

crm:
Thanks for the reply i will try that when i get home from school  

mobrien_12:
For USB mice the device is
/dev/input/mice

/dev/mouse is just a symlink, and may not be set properly.

Navigation

[0] Message Index

[#] Next page