Operating Systems > Linux and UNIX

RH 7.3 internet connection sharing

<< < (2/2)

Master of Reality:
I think he is using IP Tables and wants NAT. That HOWTO is ipchains and masquerading, is it not?

You could always try a proxy server.

Stryker:
the ip and netmask would be for the eth0, the ppp0 should be changed to eth1. if that doesn't work you may have a badly configured firewall and i can't help you there. You'll also need to make sure that all the interfaces are up, use ping to check. You'll also need ipchains to start on boot, but make sure it is set up correctly as you could block the forwarding before you accept it.

voidmain:

quote:Originally posted by The Master of Reality / Bob:
I think he is using IP Tables and wants NAT. That HOWTO is ipchains and masquerading, is it not?

You could always try a proxy server.
--- End quote ---


IP Masquerading is a form of NAT and it is what you and I are doing on our home networks which allows all of our machines on our private network to access the internet as if they were directly connected.

Master of Reality:
isnt that HOWTO using ipchains though? RH 7.* uses tables. Unless he wants to unload iptables and install ipchains.
No it doesnt.....http://www.tldp.org/HOWTO/IP-Masquerade-HOWTO/kernel-2.4.x-requirements.html
i was mistaken.... i just remember using that howto for my ipchain setup. very well. Alls good

[ September 25, 2002: Message edited by: The Master of Reality / Bob ]

Navigation

[0] Message Index

[*] Previous page