Stop Microsoft
Welcome,
Guest
. Please
login
or
register
.
Have you missed your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length.
News:
Home
Help
Login
Register
Stop Microsoft
»
Miscellaneous
»
Technical Support
»
Controlling electormagnets with my computer?
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Controlling electormagnets with my computer? (Read 4250 times)
yahurd
Member
Posts: 677
Kudos: 384
Hero of Time
Controlling electormagnets with my computer?
«
on:
8 August 2009, 12:59 »
Can anyone tell me how to individually control 10 electromagnets with a PC?
I need to be able to adjust each one individually, control the strength, shut them on, and off etc.
Can anyone tell me how to do this?
Logged
davidnix71
Member
Posts: 760
Kudos: 501
Re: Controlling electormagnets with my computer?
«
Reply #1 on:
12 August 2009, 04:02 »
The GadgetMaster
http://www.pcgadgets.com/
10 stepper motors, each connected to the trim pot of each electromagnet's control board.
Logged
yahurd
Member
Posts: 677
Kudos: 384
Hero of Time
Re: Controlling electormagnets with my computer?
«
Reply #2 on:
14 September 2009, 22:49 »
They need to oscillate, I think either between rates or on and off, at several thousand cycles per second. can gadgetmaster do that? and if not does anyone know how I could?
Logged
Lead Head
Global Moderator
Member
Posts: 1,508
Kudos: 534
Re: Controlling electormagnets with my computer?
«
Reply #3 on:
15 September 2009, 05:32 »
You will probably need to use some kind of PIC micro-controller with an amplifier board. AFAIK, there is no built in interface on a PC that can handle 10 simultaneous outputs. If it was just 1 or 2 magnets you wanted to control, the parallel port would suffice.
Logged
sig.
Aloone_Jonez
Administrator
Member
Posts: 4,090
Kudos: 954
Re: Controlling electormagnets with my computer?
«
Reply #4 on:
15 September 2009, 12:11 »
I agree, use a PIC.
How much current do the magnets draw and what voltage do they require?
If you don't need any more than 5V@500mA in total then you could power the whole thing from the USB port, otherwise you'll need a separate power supply (assuming you're not mounting this inside the PC's case). You can buy wall plugs or small switched mode power supplies quite cheaply.
You'll need a driver to power the magnets; this could just be a transistor.
This doesn't sound like a hard project but unless you have at least a basic knowledge of electronics, assembly programming and can solder you're going to struggle.
Here are some PIC tutorial sites.
http://www.gooligum.com.au/tut_baseline.html
http://www.winpicprog.co.uk/pic_tutorial.htm
http://www.mstracey.btinternet.co.uk/index.htm
Logged
This is not a Windows help forum, however please do feel free to sign up and agree or disagree with our views on Microsoft.
Oh and
FUCK
Microsoft! :fu:
Print
Pages: [
1
]
Go Up
« previous
next »
Stop Microsoft
»
Miscellaneous
»
Technical Support
»
Controlling electormagnets with my computer?